Application Process
 

•
Remove dirt and oil using STARTM 100 degreaser. Add 50-75 gm/litres in water (1kg STARTM 100 in 15-20 litres water), stir and dissolve. Apply liquid STARTM 100 Degreaser onto the surface for 5-10 minutes. Then rinse the surface thoroughly with water. 
(Step 1 & 5 can be avoided for STARTM GelTM on weld seam application)
•
Apply STARTM Gel TM on the weld seams and surrounding areas with a nylon plastic brush.
•
Leave the STARTM  GelTM on the weld seams areas for 20-45 minutes depending upon the thickness of oxide scale.
•
Use pressurised water Jet Spray or wipe the weld seam lightly with plastic scrubber & rinse the surface thoroughly with water.
•
Apply STARTM Passivation (STARTM Pass 1) on the surface area and leave it for about 15 minutes. This will prevent from further contamination and corrosion.
•
Rinse the surface area thoroughly with water and allow it to dry.
   

.