The SLB 5012/25 Shrink Tunnel is a highly cost-effective tunnel
A special air-circulation system saves energy by recovering residual heat, then re-using it for heating up
Electronic temperature control and a variable air supply on all sides, plus high insulation, guarantee reduced energy consumption with optimum adaptation to the product

.

The T-85 Shrink Tunnel is used to shrink-wrap products wrapped in film
The tunnel comes with 2 heating zones and 2 blower motors to achieve optimum shrink result within an 85 cm long shrink chamber
Two open-coil heaters on each side of the blowers help to maintain constant air temperature
A variable-speed roller conveyor with rotating or stationary rollers carries the product through the tunnel
The tunnel is available as painted or stainless steel
The T-85 is also available as T-85X for an extra-wide and extra-high shrink chamber

.

The 65 ST Series Shrink Tunnel comes with a 65 cm x 1 m shrink chamber that is suitable for shrink bundling of collated / stacked products in LDPE shrink film 
The tunnel can also be used with Tandem Wrappers that bundle products in two lanes and with In-Line Tray Wrappers
The chamber length can be extended for higher speeds
The shrink chamber can be 25 cm, 30 cm, 35 cm, 40 cm or 45 cm high
A heavy-duty conveyor is available for heavier products. The cooling fan at exit is standard
The tunnels are available in painted or stainless steel material

.